Sailfish 30-06 CC Rochester NY

The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

Oak Orchard Canoe & Kayak
(585) 288-5550
1350 Empire Blvd
Rochester, NY
Services
Oak Orchard Canoe & Kayak

Data Provided by:
Bayside Boat & Tackle
(585) 224-8289
1350 Empire Boulevard
Rochester, NY
 
Canvas Maam Limited
(585) 544-7150
70 Pattonwood Dr
Rochester, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Navy Point Marine Steson Sie
(585) 266-3980
Rochester, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Bryce Marine
(585) 352-9485
1682 Manitou Rd.
Rochester, NY
 
McMillan Marine
(585) 288-2180
1070 Empire Boulevard
Rochester, NY
 
Allens Canalside Marine Inc
(585) 426-5400
416 Elmgrove Rd
Rochester, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Smith Boys Of Rochester
(585) 467-4020
55 Marina Drive
Rochester, NY
 
Sutters Marine
(585) 482-4112
512 Bay St # S
Rochester, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Medical Seapak Company
(585) 266-3136
1945 Ridge Rd E
Rochester, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Data Provided by:

Sailfish 30-06 CC

Provided by:

Click here for more content from JDPower.com

Model Introduction
The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

Construction
The skin coat of chop in DCPD resin goes down over the gelcoat, followed by a solid hull laminate of knit fiberglass in the sides and woven roving in the bottom. The hull is supported by a fiberglass, foam-cored Compsys stringer system, and the bulkheads are also foam-cored. The whole network is encapsulated in fiberglass and bonded to the hull. The transom is built of high-density poured foam-cored transom encapsulated in fiberglass. The hull-to-deck joint is bonded with urethane adhesive and stainless self-tapping screws every foot. The rubrail and the stainless insert follows with two more rows of screws fastening the joint. The one-piece cockpit/liner is bonded to the stringers with urethane putty, becoming an integral part of the boat's structure. The cabin liner is also bonded to the hull and to the cockpit liner where they meet at the aft cabin bulkhead. The Sailfish comes with a 10-year structural warranty that covers the hull against defects.

Hull Design
The Sailfish 30-06 CC has a deep-vee hull form with a sharp, deep entry and 24° of transom deadrise. Reverse running strakes (they turn up rather than down from garboard to chine), similar to the old Sea Craft hulls, run the length of the bottom. Its high freeboard increases seaworthiness, helping to prevent boarding seas, while providing high gunwale coamings inside the cockpit and a relatively high cockpit deck level above the waterline. ...

Click here to read the rest of the article at JDPower.com