Sailfish 30-06 CC Utica NY

The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

ASI Environmental
(315) 735-1777
408 1st Street
Utica, NY
 
Utica Boat Service
(315) 736-5520
5164 Commercial Drive East
Yorkville, NY
 
Garret Gallery
(315) 853-8145
7825 State Route 5
Clinton, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Riverside Marine
(315) 337-5170
6787 Martin St
Rome, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

DDS Motorsports
(315) 792-4660
2100 Oriskany St W
Utica, NY
 
Island Marine Canvas
(516) 825-3561
72 Rockaway Ave
Utica, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Bikes & Boards at Surf 'n Ski
(315) 768-1190
4480 Commercial Dr
New Hartford, NY
 
Bielejec Edward H
(315) 896-4421
8196 State Route 12
Barneveld, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Express Marine
(315) 337-5720
6787 Martin St
Rome, NY
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Forestport Boat Co
(315) 392-4898
River Forestport
Utica, NY
 

Sailfish 30-06 CC

Provided by:

Click here for more content from JDPower.com

Model Introduction
The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

Construction
The skin coat of chop in DCPD resin goes down over the gelcoat, followed by a solid hull laminate of knit fiberglass in the sides and woven roving in the bottom. The hull is supported by a fiberglass, foam-cored Compsys stringer system, and the bulkheads are also foam-cored. The whole network is encapsulated in fiberglass and bonded to the hull. The transom is built of high-density poured foam-cored transom encapsulated in fiberglass. The hull-to-deck joint is bonded with urethane adhesive and stainless self-tapping screws every foot. The rubrail and the stainless insert follows with two more rows of screws fastening the joint. The one-piece cockpit/liner is bonded to the stringers with urethane putty, becoming an integral part of the boat's structure. The cabin liner is also bonded to the hull and to the cockpit liner where they meet at the aft cabin bulkhead. The Sailfish comes with a 10-year structural warranty that covers the hull against defects.

Hull Design
The Sailfish 30-06 CC has a deep-vee hull form with a sharp, deep entry and 24° of transom deadrise. Reverse running strakes (they turn up rather than down from garboard to chine), similar to the old Sea Craft hulls, run the length of the bottom. Its high freeboard increases seaworthiness, helping to prevent boarding seas, while providing high gunwale coamings inside the cockpit and a relatively high cockpit deck level above the waterline. ...

Click here to read the rest of the article at JDPower.com