Setting Up Control Systems Buffalo NY

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

Frontier Plating Co.
(716) 896-2811
68 Buell Ave.
Buffalo, NY
 
Service Canvas Co., Inc.
(716) 853-0558
149 Swan St.
Buffalo, NY
 
EMCOM Industries, Inc.
(716) 852-3711
235 Genesee St.
Buffalo, NY
 
Temple Inland
(716) 852-2144 ext. 112
100 Bud Mill Dr.
Buffalo, NY
 
AccuMED Innovative Technologies, Inc.
(716) 853-1800
150 Bud Mil Dr.
Buffalo, NY
 
Del Monte Foods/Del Monte Pet Products
(716) 891-6600
243 Urban St.
Buffalo, NY
 
Graphic Controls, LLC
(716) 853-7500
400 Exchange St.
Buffalo, NY
 
Eastman Machine Company
(716) 856-2200
779 Washington St.
Buffalo, NY
 
Chemical Distributors, Inc.
(716) 856-2300
80 Metcalfe St.
Buffalo, NY
 
CPL Niagara
(716) 887-3400
100 Forest Ave.
Buffalo, NY
 

Setting Up Control Systems

Provided By:

Source: ProAV MAGAZINE
Publication date: May 5, 2009

By Pro AV Staff

Before You Begin

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

It's important to engage with the control software programmer to understand how the connected equipment should respond to specific user commands from the control panel. Will one button power on an AV device and activate the source? Will another button also lower shades and adjust lights?

Common Control Signal Types

  • Ethernet: It uses an RJ45 connector and can connect devices enterprisewide, especially for remotely monitoring AV systems. Any Wi-Fi access points needed for control will likely connect to networks via Ethernet.
  • Infrared (IR): IR can be wireless (up to 40 feet, not usually bidirectional) or wired (up to 250 feet). If you're unsure whether an wireless IR transmitted is actually transmitting, point a camera at it and see if a red light appears in the viewfinder.
  • RS-232: This bidirectional signal type is usually terminated using a DB-9 connector. Bidirectional control is preferred over unidirectional control because devices can receive control commands.

Click here to read full article from Pro AV Magazine