Setting Up Control Systems Poughkeepsie NY

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

Berner Financial Services
(845) 471-2872
47 S. Hamilton Street
Poughkeepsier, NY
 
Commonwealth Advisors Ltd.
(845) 255-5888
70 North Putt Corners Road
New Paltz, NY
 
Accent Financial Group
(845) 255-1341
243 Main Street, Suite 130
Ratick, NY
 
Edward Jones
(845) 255-2955
243 Main Street , Suite 100
New Paltz, NY
 
New Horizons Asset Management Group, LLC
(845) 567-3930
11 Racquet Rd
Newburgh, NY
 
Prism Solar Technologies
(845) 883-4200
180 South Street
Highland, NY
 
Deep-Six Underwater Systems, Inc.
(845) 255-7446
14 Deerpath Drive
New Paltz, NY
 
Viking Industries Inc.
(845) 883-6325
PO Box 249
New Paltz, NY
 
Ultra Seal Corporation
(845) 255-2490
521 Main Street
New Paltz, NY
 
Foster & Schmalkuche, P.C.
(845) 255-1813
2135 Route 44/55
Gardiner, NY
 

Setting Up Control Systems

Provided By:

Source: ProAV MAGAZINE
Publication date: May 5, 2009

By Pro AV Staff

Before You Begin

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

It's important to engage with the control software programmer to understand how the connected equipment should respond to specific user commands from the control panel. Will one button power on an AV device and activate the source? Will another button also lower shades and adjust lights?

Common Control Signal Types

  • Ethernet: It uses an RJ45 connector and can connect devices enterprisewide, especially for remotely monitoring AV systems. Any Wi-Fi access points needed for control will likely connect to networks via Ethernet.
  • Infrared (IR): IR can be wireless (up to 40 feet, not usually bidirectional) or wired (up to 250 feet). If you're unsure whether an wireless IR transmitted is actually transmitting, point a camera at it and see if a red light appears in the viewfinder.
  • RS-232: This bidirectional signal type is usually terminated using a DB-9 connector. Bidirectional control is preferred over unidirectional control because devices can receive control commands.

Click here to read full article from Pro AV Magazine