Setting Up Control Systems Yonkers NY

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

Ryan Beck
(201) 748-4900
111 Town Square Pl Ste 530
Jersey City, NJ
 
Intelligent Switch
(201) 459-9243
40 Newport Pkwy Apt 512
Jersey City, NJ
 
N W Financial
(201) 656-0115
15 Exchange Pl
Jersey City, NJ
 
Robert Half Finance & Accounting
(201) 239-5801
1520 Plaza Five
Jersey City, NJ
 
Citifinancial
(201) 332-5068
840 Bergen Ave
Jersey City, NJ
 
Knight Capital Group
(201) 222-9400
545 Washington Blvd Fl 1
Jersey City, NJ
 
Nachbaur Joe
(201) 222-8866
505 Central Ave
Jersey City, NJ
 
Spear Leeds & Kellogg
(201) 309-4580
10 Exchange Pl
Jersey City, NJ
 
Galaxia International
(201) 239-4554
2801 John F Kennedy Blvd Apt A11
Jersey City, NJ
 
American Bio Med Instrument
(718) 235-8900
11 Wyona Street
Brooklyn, NY
 

Setting Up Control Systems

Provided By:

Source: ProAV MAGAZINE
Publication date: May 5, 2009

By Pro AV Staff

Before You Begin

All control systems should start with a design plan that includes button-by-button specifications for the included control panels. It should also spell out the necessary equipment (with address settings), cable and termination types, and mounting methods, plus a system diagram showing all the devices controlling and being controlled, from user interface to lighting fixture, for example.

It's important to engage with the control software programmer to understand how the connected equipment should respond to specific user commands from the control panel. Will one button power on an AV device and activate the source? Will another button also lower shades and adjust lights?

Common Control Signal Types

  • Ethernet: It uses an RJ45 connector and can connect devices enterprisewide, especially for remotely monitoring AV systems. Any Wi-Fi access points needed for control will likely connect to networks via Ethernet.
  • Infrared (IR): IR can be wireless (up to 40 feet, not usually bidirectional) or wired (up to 250 feet). If you're unsure whether an wireless IR transmitted is actually transmitting, point a camera at it and see if a red light appears in the viewfinder.
  • RS-232: This bidirectional signal type is usually terminated using a DB-9 connector. Bidirectional control is preferred over unidirectional control because devices can receive control commands.

Click here to read full article from Pro AV Magazine